Design for Manufacturability (DFM) Tips

The suggestions in the link below are very conservative, not realistic for high density designs with fine pitch parts.  However good advice for simple low cost designs.

http://www.circuitservices.com/baretips.htm

'via Blog this'

Conductive Fill or Non-Conductive Fill ?

“Which is the Best Choice for My Design?”

"90% or more products today specify non-conductive epoxy"

'via Blog this'

How to Avoid Common Signal Integrity Issues in Your Designs

How to Avoid Common Signal Integrity Issues in Your Designs: - Barry Olney

'via Blog this'